1.     The Image Input area displays "No signal detected"

This issue typically occurs when a laptop or other VGA device is not properly connected to the MC-100's image capture card located in the back of the unit.

Ensure that your VGA image source is properly connected via a VGA cable.  Ensure that all connections are firmly inserted.

If you're connection appears correct then use the Reconnect Devices... command from the Tools menu within the MC-100 Operator Console.

If these steps have not resolved the issue, try the following:

1.  Connect the VGA image device to the MC-100's frame capture card, ensuring a firm connection on both ends

2.  Exit the MC-100 Operator Console

3.  Reboot Windows (keep the VGA device connected to the MC-100 during reboot)

4.  With the VGA device still connected to the MC-100 - Launch the MC-100 Operator Console

5.  The Image Input area should now display the VGA device's screen